Idea
In short
How do you build a three 3.3 V regulators compared?
Feed three small 3.3 V regulators from a falling input and see which one holds its output the longest, then compare their idle current. You need MCP1700 LDO 3.3 V, AP2112K 3.3 V LDO, XC6206 3.3 V LDO (SOT-23), 9 V battery, 9 V battery snap with DC jack, Resistor 330 Ω × 3, Digital multimeter and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Measure regulator dropout.
Parts list
- Power
- Power
- Power
- Batteries
- Power
- PassivesResistor 330 Ω × 3
- Tools & Instruments
- Prototyping
How to build it
- Wire each regulator with its capacitors
- Load each with the same resistor
- Lower the input in steps
- Note where the output starts to fall
- Measure the idle current
Common questions
What parts do I need for the three 3.3 V regulators compared?
MCP1700 LDO 3.3 V, AP2112K 3.3 V LDO, XC6206 3.3 V LDO (SOT-23), 9 V battery, 9 V battery snap with DC jack, Resistor 330 Ω × 3, Digital multimeter and Breadboard 830 Tie Points.
How long does the three 3.3 V regulators compared take to build?
About 150 minutes for a intermediate maker.
