Idea
In short
How do you build a wireless power transfer demo?
A Royer oscillator drives a coil and lights an LED in a second coil a few centimetres away, showing how phone wireless charging works. You need IRFZ44N N-channel MOSFET × 2, Enamelled copper wire (magnet wire, 0.3 mm), Polyester film capacitor 100 nF (630 V) × 2, Resistor 1 kΩ × 2, Signal Diode 1N4148 × 2, Inductor 100 µH, LED 5 mm white and 12 V 2 A DC adapter.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Build a resonant oscillator and see coupling fall with distance.
Parts list
- Semiconductors
- Cables & Wires
- Passives
- PassivesResistor 1 kΩ × 2
- Semiconductors
- Passives
- Optoelectronics
- Power
How to build it
- Wind a 10-turn centre-tapped transmit coil and a 10-turn receive coil
- Build the two-MOSFET Royer oscillator
- Put the LED across the receive coil
- Measure how brightness drops with distance and angle
- Watch the MOSFETs' temperature
Common questions
What parts do I need for the wireless power transfer demo?
IRFZ44N N-channel MOSFET × 2, Enamelled copper wire (magnet wire, 0.3 mm), Polyester film capacitor 100 nF (630 V) × 2, Resistor 1 kΩ × 2, Signal Diode 1N4148 × 2, Inductor 100 µH, LED 5 mm white and 12 V 2 A DC adapter.
How long does the wireless power transfer demo take to build?
About 150 minutes for a intermediate maker.
