Projects / Ideas / Three USB-serial chips compared

Three USB-serial chips compared

BeginnerCommunicationIdeaReviewed
In short

How do you build a three USB-serial chips compared?

Use three breakout boards in turn to talk to the same board and compare drivers, speeds and the quirks of each chip. You need Arduino Uno R3, CP2102 USB to UART IC, CH340G USB to serial IC, FT232RL USB to UART IC, USB A to micro-USB cable (data) and Breadboard 830 Tie Points.

Level
Beginner
Time
About 120 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Compare USB-to-serial chips.

Parts list

How to build it

  1. Check each board runs at 3.3 V or 5 V
  2. Wire TX and RX crossed
  3. Send a test string
  4. Raise the speed
  5. Note which needs a driver

Related projects

Common questions

What parts do I need for the three USB-serial chips compared?

Arduino Uno R3, CP2102 USB to UART IC, CH340G USB to serial IC, FT232RL USB to UART IC, USB A to micro-USB cable (data) and Breadboard 830 Tie Points.

How long does the three USB-serial chips compared take to build?

About 120 minutes for a beginner maker.