Projects / Ideas / Bat detector

Bat detector

AdvancedAudio & MusicIdeaReviewed
In short

How do you build a bat detector?

A heterodyne receiver brings bat calls at 40 kHz down to an audible tone you can hear in headphones. You need NE5532 dual low-noise op-amp, CD4046 phase-locked loop, CD4066 quad bilateral switch, Electret microphone (capsule), Potentiometer 10 kΩ, LM386 amplifier module, Headphone jack module 3.5 mm, 9 V battery, 9 V battery snap with DC jack and Perfboard (dot PCB) 7 × 9 cm.

Level
Advanced
Time
About 360 min
Parts
10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Mix two frequencies to shift a signal into hearing range.

How to build it

  1. Amplify the mic with high gain
  2. Make a tunable oscillator around 40 kHz
  3. Mix the two with the analog switch
  4. Filter to keep the difference tone
  5. Tune across the band at dusk

Related projects

Common questions

What parts do I need for the bat detector?

NE5532 dual low-noise op-amp, CD4046 phase-locked loop, CD4066 quad bilateral switch, Electret microphone (capsule), Potentiometer 10 kΩ, LM386 amplifier module, Headphone jack module 3.5 mm, 9 V battery, 9 V battery snap with DC jack and Perfboard (dot PCB) 7 × 9 cm. Electret microphone (capsule): Use a MEMS mic that reaches 50 kHz.

How long does the bat detector take to build?

About 360 minutes for a advanced maker.