Idea
In short
How do you build a stepper pointer gauge?
A small stepper moves a paper needle across a printed dial to show a value like a car gauge. You need Arduino Nano, ULN2003 driver board, 28BYJ-48 Stepper Motor, Potentiometer 10 kΩ and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Show a value with a moving needle.
Parts list
- Development Boards
- Motor Drivers
- Motors & Actuators
- Passives
- Prototyping
How to build it
- Wire the driver board
- Home the needle to zero
- Read a knob
- Map the value to steps
- Move smoothly to the target
Common questions
What parts do I need for the stepper pointer gauge?
Arduino Nano, ULN2003 driver board, 28BYJ-48 Stepper Motor, Potentiometer 10 kΩ and Breadboard 830 Tie Points.
How long does the stepper pointer gauge take to build?
About 240 minutes for a intermediate maker.
