Projects / Ideas / Eight-line level shifter test

Eight-line level shifter test

BeginnerCommunicationIdeaReviewed
In short

How do you build an eight-line level shifter test?

Pass eight signals between a 3.3 V board and a 5 V board through a level shifter and check each edge with a scope. You need Arduino Nano, Raspberry Pi Pico H, TXS0108E 8-channel level shifter, Tactile push button 6 mm × 2, Resistor 10 kΩ × 2, Digital oscilloscope 2-channel 100 MHz and Breadboard 830 Tie Points.

Level
Beginner
Time
About 150 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Shift eight lines between voltages.

Parts list

How to build it

  1. Power both sides from their own rails
  2. Send a pattern
  3. Read it on the other side
  4. Check the edges on a scope
  5. Test the enable pin

Related projects

Common questions

What parts do I need for the eight-line level shifter test?

Arduino Nano, Raspberry Pi Pico H, TXS0108E 8-channel level shifter, Tactile push button 6 mm × 2, Resistor 10 kΩ × 2, Digital oscilloscope 2-channel 100 MHz and Breadboard 830 Tie Points.

How long does the eight-line level shifter test take to build?

About 150 minutes for a beginner maker.