Projects / Ideas / 3.3 V input clamp for a 5 V signal

3.3 V input clamp for a 5 V signal

BeginnerCommunicationIdeaReviewed
In short

How do you build a 3.3 V input clamp for a 5 V signal?

A series resistor and a 3.3 V zener hold a 5 V signal at a safe level for a 3.3 V input, with a scope check of the edges. You need Arduino Nano, Zener diode 3.3 V (1N4728A), Resistor 1 kΩ, Resistor 10 kΩ, Digital oscilloscope 2-channel 100 MHz and Breadboard 830 Tie Points.

Level
Beginner
Time
About 120 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Protect a 3.3 V pin.

Parts list

How to build it

  1. Work out the series resistor
  2. Add the zener at the pin
  3. Drive it from 5 V
  4. Measure the clamp voltage
  5. Compare with a resistor divider

Related projects

Common questions

What parts do I need for the 3.3 V input clamp for a 5 V signal?

Arduino Nano, Zener diode 3.3 V (1N4728A), Resistor 1 kΩ, Resistor 10 kΩ, Digital oscilloscope 2-channel 100 MHz and Breadboard 830 Tie Points.

How long does the 3.3 V input clamp for a 5 V signal take to build?

About 120 minutes for a beginner maker.