Idea
In short
How do you build a two-transistor memory latch?
Two BC547 transistors hold one bit: a set button lights one LED and a reset button lights the other, and the state stays after you let go. You need BC547 NPN transistor × 2, Resistor 1 kΩ × 2, Resistor 47 kΩ × 2, Tactile push button 6 mm × 2, LED 5 mm red, LED 5 mm green, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 120 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
See how a latch remembers.
Parts list
- Semiconductors
- PassivesResistor 1 kΩ × 2
- PassivesResistor 47 kΩ × 2
- Switches
- Semiconductors
- Semiconductors
- Batteries
- Power
- Prototyping
How to build it
- Cross-couple the two transistors
- Add the set and reset buttons
- Watch which LED holds
- Remove power to see it forget
- Add a third input to reset both
Common questions
What parts do I need for the two-transistor memory latch?
BC547 NPN transistor × 2, Resistor 1 kΩ × 2, Resistor 47 kΩ × 2, Tactile push button 6 mm × 2, LED 5 mm red, LED 5 mm green, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
How long does the two-transistor memory latch take to build?
About 120 minutes for a beginner maker.
