Projects / Ideas / Diode logic AND and OR lab

Diode logic AND and OR lab

BeginnerDigital LogicIdeaReviewed
In short

How do you build a diode logic AND and OR lab?

Build an AND gate and an OR gate from small diodes and resistors, test every input combination with LEDs and a multimeter, and see the voltage lost in each diode. It shows why real chips use transistors. You need Signal Diode 1N4148 × 4, Resistor 10 kΩ × 2, Resistor 1 kΩ, LED 5 mm red, Resistor 330 Ω, Tactile push button 6 mm × 2, 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 60 min
Parts
10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Make logic gates from diodes and see their limits.

How to build it

  1. Wire the diode OR gate
  2. Test the four input patterns
  3. Wire the diode AND gate
  4. Test it the same way
  5. Measure the lost voltage and explain it

Related projects

Common questions

What parts do I need for the diode logic AND and OR lab?

Signal Diode 1N4148 × 4, Resistor 10 kΩ × 2, Resistor 1 kΩ, LED 5 mm red, Resistor 330 Ω, Tactile push button 6 mm × 2, 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the diode logic AND and OR lab take to build?

About 60 minutes for a beginner maker.