Idea
In short
How do you build a mini sumo practice bot?
A small robot pushes objects out of a ring using ultrasonic sensing and edge sensors. You need Arduino Uno R3, HC-SR04 Ultrasonic Sensor, TCRT5000 IR reflective sensor module × 2, TT gear motor 3 to 6 V × 2, TB6612FNG Motor Driver, 18650 Li-ion cell × 2, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Advanced
- Time
- About 360 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Combine edge detection and target search.
Parts list
- Development Boards
- Sensors
- Sensors
- Motors & Actuators
- Motor Drivers
- Power
- Prototyping
- Prototyping
How to build it
- Build a low chassis
- Detect white ring edges
- Search by spinning
- Charge at a target
- Back off at an edge
Common questions
What parts do I need for the mini sumo practice bot?
Arduino Uno R3, HC-SR04 Ultrasonic Sensor, TCRT5000 IR reflective sensor module × 2, TT gear motor 3 to 6 V × 2, TB6612FNG Motor Driver, 18650 Li-ion cell × 2, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the mini sumo practice bot take to build?
About 360 minutes for a advanced maker.
