Idea
In short
How do you build a timed watering valve?
A clock opens a small low-voltage valve for a short time each day to water one pot. Keep the electronics away from the water. You need Arduino Nano, 12 V solenoid water valve, IRLZ34N logic-level MOSFET, Rectifier Diode 1N4007, DS3231 RTC module, 12 V 2 A DC adapter, Resistor 10 kΩ and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 270 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Water a pot on a schedule.
Parts list
- Development Boards
- Motors & Actuators
- Semiconductors
- Semiconductors
- Sensors
- Power
- Passives
- Prototyping
How to build it
- Wire the MOSFET driver
- Add the flyback diode
- Set a daily time
- Open for ten seconds
- Add a manual test button
Common questions
What parts do I need for the timed watering valve?
Arduino Nano, 12 V solenoid water valve, IRLZ34N logic-level MOSFET, Rectifier Diode 1N4007, DS3231 RTC module, 12 V 2 A DC adapter, Resistor 10 kΩ and Breadboard 830 Tie Points.
How long does the timed watering valve take to build?
About 270 minutes for a intermediate maker.
