Idea
In short
How do you build a soldering iron auto sleep?
A tilt or vibration sensor in the iron stand turns the iron off when it rests too long. You need Arduino Nano, Vibration sensor module (SW-420), Relay Module 5V, Active buzzer 5 V and Tactile push button 6 mm.
- Level
- Intermediate
- Time
- About 60 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Add a safety timer to a tool.
Parts list
- Development Boards
- Sensors
- Interfaces
- Motors & Actuators
- Switches
How to build it
- Sense when the iron is in the stand
- Start a 10-minute timer
- Beep, then cut power
- Wake when it is lifted
- Leave the mains wiring to an electrician
Common questions
What parts do I need for the soldering iron auto sleep?
Arduino Nano, Vibration sensor module (SW-420), Relay Module 5V, Active buzzer 5 V and Tactile push button 6 mm.
How long does the soldering iron auto sleep take to build?
About 60 minutes for a intermediate maker.
