Idea
In short
How do you build a capacitive touch switch panel?
Four touch pads behind glass switch four relays, with LED rings that show which lights are on. You need Arduino Nano, Capacitive touch keypad (TTP229, 16 key), Relay module 4-channel 5 V, LED 5 mm blue × 4 and Resistor 330 Ω × 4.
- Level
- Intermediate
- Time
- About 120 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Read capacitive touch sensors and debounce touches.
Parts list
- Development Boards
- Sensors
- Interfaces
- OptoelectronicsLED 5 mm blue × 4
- PassivesResistor 330 Ω × 4
How to build it
- Mount the TTP229 behind a thin acrylic sheet
- Read the touched key over its two-wire interface
- Toggle the matching relay
- Light the matching LED
- Ignore touches shorter than 50 ms
Common questions
What parts do I need for the capacitive touch switch panel?
Arduino Nano, Capacitive touch keypad (TTP229, 16 key), Relay module 4-channel 5 V, LED 5 mm blue × 4 and Resistor 330 Ω × 4.
How long does the capacitive touch switch panel take to build?
About 120 minutes for a intermediate maker.
