Idea
In short
How do you build a power strip sequencer?
Turn on the amplifier, then the speakers, with delays, and off in reverse order. You need Arduino Nano, Relay module 4-channel 5 V, Tactile push button 6 mm, LED 5 mm red × 4 and Resistor 220 Ω × 4.
- Level
- Intermediate
- Time
- About 90 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Sequence loads.
Parts list
- Development Boards
- Interfaces
- Switches
- SemiconductorsLED 5 mm red × 4
- PassivesResistor 220 Ω × 4
How to build it
- Press once to start
- Switch relays with delays
- Reverse on stop
- Show state with LEDs
- Have a qualified electrician wire the mains side
Common questions
What parts do I need for the power strip sequencer?
Arduino Nano, Relay module 4-channel 5 V, Tactile push button 6 mm, LED 5 mm red × 4 and Resistor 220 Ω × 4.
How long does the power strip sequencer take to build?
About 90 minutes for a intermediate maker.
