Idea
In short
How do you build an eight-switch bus board?
A resistor network and a bus buffer carry eight switches to eight LEDs, showing what pull-ups and buffers do. You need 74HC245 octal bus transceiver, Resistor network 10 kΩ (9-pin SIP), LED 5 mm red × 8, Resistor 330 Ω × 8, Tactile push button 6 mm × 2 and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 150 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Move eight bits through a buffer.
Parts list
- Integrated Circuits
- Passives
- SemiconductorsLED 5 mm red × 8
- PassivesResistor 330 Ω × 8
- Switches
- Prototyping
How to build it
- Wire the pull-up network
- Wire the eight switches
- Wire the buffer
- Light the LEDs
- Use the direction and enable pins
Common questions
What parts do I need for the eight-switch bus board?
74HC245 octal bus transceiver, Resistor network 10 kΩ (9-pin SIP), LED 5 mm red × 8, Resistor 330 Ω × 8, Tactile push button 6 mm × 2 and Breadboard 830 Tie Points.
How long does the eight-switch bus board take to build?
About 150 minutes for a beginner maker.
