Idea
In short
How do you build a data bus with transceivers?
Two registers share an 8-bit bus through 74HC245 transceivers, and switches choose who drives it. You need 74HC245 octal bus transceiver × 2, 74HC573 octal latch × 2, DIP switch 8-position × 2, LED 5 mm red × 8, Resistor 330 Ω × 8, Resistor 10 kΩ × 16, Breadboard 1660 points (with base) and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Learn how a shared bus works.
Parts list
- Integrated Circuits
- Integrated Circuits
- Switches
- SemiconductorsLED 5 mm red × 8
- PassivesResistor 330 Ω × 8
- PassivesResistor 10 kΩ × 16
- Prototyping
- Prototyping
How to build it
- Load data into one latch
- Enable its transceiver onto the bus
- Latch the bus into the other register
- Make sure only one drives at a time
- Watch the LEDs
Common questions
What parts do I need for the data bus with transceivers?
74HC245 octal bus transceiver × 2, 74HC573 octal latch × 2, DIP switch 8-position × 2, LED 5 mm red × 8, Resistor 330 Ω × 8, Resistor 10 kΩ × 16, Breadboard 1660 points (with base) and Jumper wires male to male (40 pcs, 20 cm).
How long does the data bus with transceivers take to build?
About 240 minutes for a intermediate maker.
