Idea
In short
How do you build a school bus child check?
The driver must press a button at the back of the bus after parking, proving the bus was checked. You need Arduino Nano, Tactile push button 6 mm, PIR Motion Sensor HC-SR501, Active buzzer 5 V, DS3231 RTC module, MicroSD Card Module and SanDisk microSD card 32 GB (A1, Class 10).
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Build a check-in system.
Parts list
- Development Boards
- Switches
- Sensors
- Motors & Actuators
- Sensors
- Interfaces
- SBC Accessories
How to build it
- Beep when the engine stops
- Require the rear button within a minute
- Log the check
- Alert if missed
- Use PIR to find a left-behind child
Common questions
What parts do I need for the school bus child check?
Arduino Nano, Tactile push button 6 mm, PIR Motion Sensor HC-SR501, Active buzzer 5 V, DS3231 RTC module, MicroSD Card Module and SanDisk microSD card 32 GB (A1, Class 10).
How long does the school bus child check take to build?
About 150 minutes for a intermediate maker.
