Idea
In short
How do you build a heater safety monitor?
A bedroom unit checks CO and temperature and turns off a relay controlling a heater if levels rise. You need Arduino Nano, MQ-7 carbon monoxide sensor module, DHT22 Sensor, Relay Module 5V, Active buzzer 5 V and Resistor 10 kΩ.
- Level
- Intermediate
- Time
- About 120 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Make a protective switch.
Parts list
- Development Boards
- Sensors
- Sensors
- Interfaces
- Motors & Actuators
- Passives
How to build it
- Warm the sensor
- Set CO and heat limits
- Cut the relay on alarm
- Beep and flash
- Leave mains work to an electrician
Common questions
What parts do I need for the heater safety monitor?
Arduino Nano, MQ-7 carbon monoxide sensor module, DHT22 Sensor, Relay Module 5V, Active buzzer 5 V and Resistor 10 kΩ.
How long does the heater safety monitor take to build?
About 120 minutes for a intermediate maker.
