Idea
In short
How do you build a four-servo robot arm teach pendant?
Move four pots to pose a small arm, then save and replay sequences. You need Arduino Uno R3, MG90S metal gear micro servo × 4, Potentiometer 10 kΩ × 4, Tactile push button 6 mm × 2, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Advanced
- Time
- About 300 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Record and replay servo poses.
Parts list
- Development Boards
- Motors & Actuators
- Passives
- Switches
- Prototyping
- Prototyping
How to build it
- Read four pots
- Move each servo
- Save poses in EEPROM
- Replay a sequence
- Add speed control
Common questions
What parts do I need for the four-servo robot arm teach pendant?
Arduino Uno R3, MG90S metal gear micro servo × 4, Potentiometer 10 kΩ × 4, Tactile push button 6 mm × 2, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the four-servo robot arm teach pendant take to build?
About 300 minutes for a advanced maker.
