How do you build a waterproof river level monitor?
A JSN-SR04T waterproof ultrasonic sensor under a bridge measures the water level and an ESP32 sends it over LoRa to a village receiver. You need ESP32 DevKit V1, JSN-SR04T waterproof ultrasonic sensor, DS18B20 Temperature Sensor, Resistor 4.7 kΩ, RFM95W LoRa module (868 MHz), 868 MHz LoRa antenna, 18650 cell 2600 mAh (branded), Battery holder 18650 single, Solar panel 6 V 1 W, CN3065 solar Li-ion charger module and Waterproof enclosure IP65 (junction box).
- Level
- Advanced
- Time
- About 300 min
- Parts
- 11
Measure distance outdoors with temperature compensation and send compact readings over a long-range link.
Parts list
- Development Boards
- Sensors
- Sensors
- Passives
- Wireless
- Wireless
- Batteries
- Power
- Power
- Power
- Mechanical & Hardware
How to build it
- Mount the sensor pointing straight down at the water, with nothing in its cone
- Correct the speed of sound with air temperature from the DS18B20
- Take the median of 9 readings to reject splashes
- Send level and battery voltage every 15 minutes at 866 MHz
- Raise an alert at the receiver when the level rises faster than a set rate
Common questions
What parts do I need for the waterproof river level monitor?
ESP32 DevKit V1, JSN-SR04T waterproof ultrasonic sensor, DS18B20 Temperature Sensor, Resistor 4.7 kΩ, RFM95W LoRa module (868 MHz), 868 MHz LoRa antenna, 18650 cell 2600 mAh (branded), Battery holder 18650 single, Solar panel 6 V 1 W, CN3065 solar Li-ion charger module and Waterproof enclosure IP65 (junction box).
How long does the waterproof river level monitor take to build?
About 300 minutes for a advanced maker.
