How do you build a solar-powered weather station?
An ESP32 weather station on a pole reads temperature, humidity, pressure and light, sleeps between readings and runs on a solar-charged 18650 cell. You need ESP32 DevKit V1, BME280 Environmental Sensor, BH1750 light sensor, Solar panel 6 V 1 W, CN3065 solar Li-ion charger module, 18650 cell 2600 mAh (branded), Battery holder 18650 single, HT7333 low quiescent LDO and Waterproof enclosure IP65 (junction box).
- Level
- Advanced
- Time
- About 240 min
- Parts
- 9
Design a battery and solar budget so an outdoor sensor node runs for months without attention.
Parts list
- Development Boards
- Sensors
- Sensors
- Power
- Power
- Batteries
- Power
- Power
- Mechanical & Hardware
How to build it
- Measure the ESP32's current awake and in deep sleep with a USB power meter
- Wire the BME280 and BH1750 on one I2C bus
- Charge the cell from the panel through the CN3065 and feed the ESP32 through the low-quiescent LDO
- Wake every 10 minutes, read, send over Wi-Fi, then deep sleep
- Mount in a vented IP65 box out of direct sun and log the battery voltage for a week
Common questions
What parts do I need for the solar-powered weather station?
ESP32 DevKit V1, BME280 Environmental Sensor, BH1750 light sensor, Solar panel 6 V 1 W, CN3065 solar Li-ion charger module, 18650 cell 2600 mAh (branded), Battery holder 18650 single, HT7333 low quiescent LDO and Waterproof enclosure IP65 (junction box).
How long does the solar-powered weather station take to build?
About 240 minutes for a advanced maker.
