Idea
In short
How do you build a precision half-wave rectifier?
An op-amp and a diode rectify a small AC signal without the 0.6 V diode loss, shown against a plain diode rectifier by measuring the output peak. You need LM358 Op-Amp, Signal Diode 1N4148 × 2, Resistor 10 kΩ × 2, 9 V battery × 2, 9 V battery snap with DC jack × 2, Digital multimeter and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Rectify tiny signals accurately.
Parts list
- Integrated Circuits
- Semiconductors
- PassivesResistor 10 kΩ × 2
- Batteries9 V battery × 2
- Power
- Tools & Instruments
- Prototyping
How to build it
- Build a split supply from two 9 V batteries
- Wire the op-amp with the diode in the feedback loop
- Feed a small tone from a phone
- Compare with a plain diode
- Measure the output peak
Common questions
What parts do I need for the precision half-wave rectifier?
LM358 Op-Amp, Signal Diode 1N4148 × 2, Resistor 10 kΩ × 2, 9 V battery × 2, 9 V battery snap with DC jack × 2, Digital multimeter and Breadboard 830 Tie Points.
How long does the precision half-wave rectifier take to build?
About 150 minutes for a intermediate maker.
