Projects / Ideas / High-side switch with a PNP transistor

High-side switch with a PNP transistor

IntermediatePowerIdeaReviewed
In short

How do you build a high-side switch with a PNP transistor?

A PNP transistor and a small helper transistor switch the positive side of a load, so the load can share ground with the board. You need Arduino Nano, 2N3906 PNP transistor, 2N3904 NPN transistor, Resistor 1 kΩ × 2, Resistor 10 kΩ, LED 5 mm red, Resistor 220 Ω and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 210 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Switch on the high side.

Parts list

How to build it

  1. Wire the PNP between supply and load
  2. Add the NPN driver
  3. Switch from a pin
  4. Measure the drop
  5. Compare with a low-side switch

Related projects

Common questions

What parts do I need for the high-side switch with a PNP transistor?

Arduino Nano, 2N3906 PNP transistor, 2N3904 NPN transistor, Resistor 1 kΩ × 2, Resistor 10 kΩ, LED 5 mm red, Resistor 220 Ω and Breadboard 830 Tie Points.

How long does the high-side switch with a PNP transistor take to build?

About 210 minutes for a intermediate maker.