Projects / Ideas / Pico wireless button and lamp pair

Pico wireless button and lamp pair

IntermediateCommunicationIdeaReviewed
In short

How do you build a pico wireless button and lamp pair?

Two Picos with nRF24L01 radios: pressing a button on one lights an LED on the other, with an acknowledgement. Radios run at 3.3 V with a decoupling capacitor. You need Raspberry Pi Pico H × 2, nRF24L01+ Radio Module × 2, Tactile push button 6 mm, LED 5 mm red, Resistor 330 Ω and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 170 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Send a simple message between boards.

Parts list

How to build it

  1. Wire each radio over SPI
  2. Set the same channel and address
  3. Send a button state
  4. Acknowledge on receipt
  5. Light the LED while pressed

Related projects

Common questions

What parts do I need for the pico wireless button and lamp pair?

Raspberry Pi Pico H × 2, nRF24L01+ Radio Module × 2, Tactile push button 6 mm, LED 5 mm red, Resistor 330 Ω and Breadboard 830 Tie Points.

How long does the pico wireless button and lamp pair take to build?

About 170 minutes for a intermediate maker.