Idea
In short
How do you build a radio remote switch pair?
A handheld nRF24 remote switches an LED box across a room, with acknowledgements. You need Arduino Nano × 2, nRF24L01+ Radio Module × 2, Tactile push button 6 mm × 2, LED 5 mm red, Resistor 220 Ω, Electrolytic Capacitor 100 µF × 2, Breadboard 830 Tie Points × 2 and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 210 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Send and acknowledge radio packets.
Parts list
- Development BoardsArduino Nano × 2
- Wireless
- Switches
- Semiconductors
- Passives
- Passives
- Prototyping
- Prototyping
How to build it
- Power the radios at 3.3 V with a capacitor
- Send a small packet
- Acknowledge it
- Switch an LED
- Add a retry on failure
Common questions
What parts do I need for the radio remote switch pair?
Arduino Nano × 2, nRF24L01+ Radio Module × 2, Tactile push button 6 mm × 2, LED 5 mm red, Resistor 220 Ω, Electrolytic Capacitor 100 µF × 2, Breadboard 830 Tie Points × 2 and Jumper wires male to male (40 pcs, 20 cm).
How long does the radio remote switch pair take to build?
About 210 minutes for a intermediate maker.
