Projects / Ideas / Pico wave-to-switch lamp

Pico wave-to-switch lamp

IntermediateLightingIdeaReviewed
In short

How do you build a pico wave-to-switch lamp?

A Pico reads gestures from an APDS-9960 sensor and switches an LED on and off when you wave a hand over it. Low voltage only. You need Raspberry Pi Pico H, APDS-9960 gesture, colour and proximity sensor, LED 5 mm red, Resistor 330 Ω and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 150 min
Parts
5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Switch a light without touching it.

How to build it

  1. Wire the sensor on I2C
  2. Enable the gesture engine
  3. Read the gesture result
  4. Toggle the LED on up or down
  5. Fade the LED with PWM

Related projects

Common questions

What parts do I need for the pico wave-to-switch lamp?

Raspberry Pi Pico H, APDS-9960 gesture, colour and proximity sensor, LED 5 mm red, Resistor 330 Ω and Breadboard 830 Tie Points.

How long does the pico wave-to-switch lamp take to build?

About 150 minutes for a intermediate maker.