Idea
In short
How do you build a peltier mini fridge controller?
A temperature probe controls a 12 V Peltier module in an insulated box to keep medicine or drinks cool. You need Arduino Nano, DS18B20 waterproof probe, Resistor 4.7 kΩ, IRLZ34N logic-level MOSFET, 12 V DC fan 80 mm, SMPS 12 V 5 A (metal case), Thermal paste and 16x2 LCD with I2C backpack (PCF8574).
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Switch a high-current thermoelectric module and manage its heat.
Parts list
- Development Boards
- Sensors
- Passives
- Semiconductors
- Motors & Actuators
- Power
- Tools & Instruments
- Displays
How to build it
- Mount the Peltier between a cold plate inside and a heatsink with fan outside
- Drive it through the MOSFET with slow PWM
- Keep the set temperature with hysteresis
- Always run the hot-side fan when the Peltier is on
- Measure how cold it gets and the power used
Common questions
What parts do I need for the peltier mini fridge controller?
Arduino Nano, DS18B20 waterproof probe, Resistor 4.7 kΩ, IRLZ34N logic-level MOSFET, 12 V DC fan 80 mm, SMPS 12 V 5 A (metal case), Thermal paste and 16x2 LCD with I2C backpack (PCF8574).
How long does the peltier mini fridge controller take to build?
About 240 minutes for a intermediate maker.
