Projects / Ideas / Parallel LEDs and one resistor

Parallel LEDs and one resistor

BeginnerLearningIdeaReviewed
In short

How do you build a parallel LEDs and one resistor?

Light three LEDs in parallel with one shared resistor and then with a resistor each, and measure the current and the brightness. See why a shared resistor gives uneven lights and why every LED needs its own. It is a classic mistake worth making once on a safe 5 volt supply. You need Arduino Nano, LED 5 mm red × 3, Resistor 220 Ω × 4, Digital multimeter, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 50 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

See why every LED needs its own resistor.

Parts list

How to build it

  1. Wire three LEDs with one shared resistor
  2. Measure the current and note the brightness
  3. Swap one LED for a different colour
  4. Wire three resistors, one per LED
  5. Compare the current and the evenness

Related projects

Common questions

What parts do I need for the parallel LEDs and one resistor?

Arduino Nano, LED 5 mm red × 3, Resistor 220 Ω × 4, Digital multimeter, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the parallel LEDs and one resistor take to build?

About 50 minutes for a beginner maker.