Projects / Ideas / Scope probe calibrator

Scope probe calibrator

BeginnerTest & MeasurementIdeaReviewed
In short

How do you build a scope probe calibrator?

A crystal-stable 1 kHz square wave for compensating oscilloscope probes. You need CD4060 counter and oscillator, Crystal 32.768 kHz (watch crystal), 74HC74 dual D flip-flop, Resistor 10 kΩ, Ceramic capacitor 22 pF × 2 and Perfboard (dot PCB) 7 × 9 cm.

Level
Beginner
Time
About 90 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Divide a crystal clock to a precise signal.

How to build it

  1. Run the 4060 with a watch crystal
  2. Take a divided output
  3. Divide again to 1 kHz
  4. Square it with the flip-flop
  5. Adjust your probes until the corners are square

Related projects

Common questions

What parts do I need for the scope probe calibrator?

CD4060 counter and oscillator, Crystal 32.768 kHz (watch crystal), 74HC74 dual D flip-flop, Resistor 10 kΩ, Ceramic capacitor 22 pF × 2 and Perfboard (dot PCB) 7 × 9 cm.

How long does the scope probe calibrator take to build?

About 90 minutes for a beginner maker.