Projects / Ideas / Bed-of-nails PCB tester

Bed-of-nails PCB tester

AdvancedTest & MeasurementIdeaReviewed
In short

How do you build a bed-of-nails PCB tester?

Spring pins in a jig contact test pads on your PCB and an Arduino checks every net for shorts and opens. You need Arduino Mega 2560 R3, Perfboard (dot PCB) 7 × 9 cm × 2, Resistor 10 kΩ × 16 and CD74HC4067 16-channel mux module × 2.

Level
Advanced
Time
About 480 min
Parts
4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Build a production test fixture.

Parts list

How to build it

  1. Design test pads on your board
  2. Make a jig with spring pins
  3. Switch each net with the mux
  4. Check expected connections
  5. Print pass or fail

Related projects

Common questions

What parts do I need for the bed-of-nails PCB tester?

Arduino Mega 2560 R3, Perfboard (dot PCB) 7 × 9 cm × 2, Resistor 10 kΩ × 16 and CD74HC4067 16-channel mux module × 2.

How long does the bed-of-nails PCB tester take to build?

About 480 minutes for a advanced maker.