Idea
In short
How do you build a transistor and component tester?
An ATmega328 identifies an unknown resistor, capacitor, diode or transistor and shows its pinout and values. You need ATmega328P-PU (blank), 16x2 LCD with I2C backpack (PCF8574), Resistor 680 Ω × 3, Resistor 470 kΩ × 3, Tactile push button 6 mm, Crystal 8 MHz, Ceramic capacitor 22 pF × 2, 9 V battery, 9 V battery snap with DC jack and Perfboard (dot PCB) 7 × 9 cm.
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Learn how a tester probes parts with three test points.
Parts list
- Integrated Circuits
- Displays
- PassivesResistor 680 Ω × 3
- PassivesResistor 470 kΩ × 3
- Switches
- Passives
- Passives
- Batteries
- Power
- Prototyping
How to build it
- Build the open-source tester circuit
- Flash its firmware
- Calibrate with the shorted probes
- Test known parts first
- Compare results with a meter
Common questions
What parts do I need for the transistor and component tester?
ATmega328P-PU (blank), 16x2 LCD with I2C backpack (PCF8574), Resistor 680 Ω × 3, Resistor 470 kΩ × 3, Tactile push button 6 mm, Crystal 8 MHz, Ceramic capacitor 22 pF × 2, 9 V battery, 9 V battery snap with DC jack and Perfboard (dot PCB) 7 × 9 cm.
How long does the transistor and component tester take to build?
About 240 minutes for a intermediate maker.
