Projects / Ideas / Nucleo two-motor driver bench

Nucleo two-motor driver bench

IntermediateRoboticsIdeaReviewed
In short

How do you build a nucleo two-motor driver bench?

A Nucleo-64 board drives two small gear motors through a TB6612FNG driver with speed set by PWM and direction by two pins, controlled from the serial console. Power the motors from their own supply and keep the wheels off the table while testing. You need STM32 Nucleo-64, TB6612FNG Motor Driver, N20 micro metal gear motor × 2, 9 V battery and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 170 min
Parts
5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Drive two motors with direction and speed control.

Parts list

How to build it

  1. Wire the driver logic from 3.3 V
  2. Power the motors separately
  3. Set direction pins
  4. Set speed by PWM
  5. Send commands over the serial console

Related projects

Common questions

What parts do I need for the nucleo two-motor driver bench?

STM32 Nucleo-64, TB6612FNG Motor Driver, N20 micro metal gear motor × 2, 9 V battery and Breadboard 830 Tie Points.

How long does the nucleo two-motor driver bench take to build?

About 170 minutes for a intermediate maker.