Projects / Ideas / Nucleo power profile logger

Nucleo power profile logger

AdvancedPowerIdeaReviewed
In short

How do you build a nucleo power profile logger?

A Nucleo-64 board reads an INA226 monitor at about a hundred samples a second and shows the voltage, current and energy used by a small low-voltage project, with the peak current. Stay within the sensor limits. You need STM32 Nucleo-64, INA226 current and power monitor, SSD1306 OLED Display and Breadboard 830 Tie Points.

Level
Advanced
Time
About 200 min
Parts
4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

See how a small project uses power over time.

How to build it

  1. Put the sensor in series with the load
  2. Set the averaging and conversion time
  3. Read voltage and current
  4. Integrate energy over time
  5. Show the peak and the total

Related projects

Common questions

What parts do I need for the nucleo power profile logger?

STM32 Nucleo-64, INA226 current and power monitor, SSD1306 OLED Display and Breadboard 830 Tie Points.

How long does the nucleo power profile logger take to build?

About 200 minutes for a advanced maker.