Idea
In short
How do you build a low-noise line preamp?
A low-noise op-amp boosts a quiet audio source and you compare the noise with a cheaper chip. You need NE5532 dual low-noise op-amp, LM358 Op-Amp, Resistor 10 kΩ × 4, Resistor 100 kΩ, Electrolytic capacitor 10 µF × 3, Audio jack 3.5 mm (PCB, stereo) × 2, 9 V battery and Breadboard 830 Tie Points.
- Level
- Advanced
- Time
- About 330 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Compare op-amp noise.
Parts list
- Integrated Circuits
- Integrated Circuits
- PassivesResistor 10 kΩ × 4
- Passives
- Passives
- Connectors
- Batteries
- Prototyping
How to build it
- Build the same gain stage twice
- Feed a quiet source
- Record the output of each
- Compare the noise floor
- Pick the better part
Common questions
What parts do I need for the low-noise line preamp?
NE5532 dual low-noise op-amp, LM358 Op-Amp, Resistor 10 kΩ × 4, Resistor 100 kΩ, Electrolytic capacitor 10 µF × 3, Audio jack 3.5 mm (PCB, stereo) × 2, 9 V battery and Breadboard 830 Tie Points.
How long does the low-noise line preamp take to build?
About 330 minutes for a advanced maker.
