Idea
In short
How do you build a bend sensor wah pedal?
A flex sensor on a foot pedal changes the cutoff of a filter, a simple wah effect for guitar. You need Flex sensor 2.2 inch, TL072 dual JFET op-amp, Resistor 10 kΩ × 3, Ceramic capacitor 10 nF × 2, Audio jack 3.5 mm (PCB, stereo) × 2, 9 V battery and 9 V battery snap with DC jack.
- Level
- Intermediate
- Time
- About 180 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Control an audio filter with a variable resistor sensor.
Parts list
- Sensors
- Integrated Circuits
- PassivesResistor 10 kΩ × 3
- Passives
- Connectors
- Batteries
- Power
How to build it
- Build a buffer with a TL072
- Add a state-variable or twin-T band-pass filter
- Replace one resistor with the flex sensor
- Fit the sensor on a pedal hinge
- Tune the range by ear
Common questions
What parts do I need for the bend sensor wah pedal?
Flex sensor 2.2 inch, TL072 dual JFET op-amp, Resistor 10 kΩ × 3, Ceramic capacitor 10 nF × 2, Audio jack 3.5 mm (PCB, stereo) × 2, 9 V battery and 9 V battery snap with DC jack.
How long does the bend sensor wah pedal take to build?
About 180 minutes for a intermediate maker.
