Projects / Ideas / Model water wheel generator

Model water wheel generator

BeginnerPowerIdeaReviewed
In short

How do you build a model water wheel generator?

A small plastic water wheel turns the shaft of a toy motor, which acts as a generator and lights an LED through a resistor. Pour water gently from a jug onto the wheel and watch the light change with the flow. Keep all wiring and the LED away from the water, use a drip tray, and only the plastic wheel gets wet. You need DC motor 130 size (toy motor), LED 5 mm red, Resistor 220 Ω, Signal Diode 1N4148, Electrolytic Capacitor 100 µF, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 60 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Light an LED from a turning water wheel.

How to build it

  1. Fit a plastic wheel to the motor shaft
  2. Wire the motor to a diode and LED
  3. Pour water slowly onto the wheel
  4. Measure the voltage with a multimeter
  5. Add a capacitor to smooth the glow

Related projects

Common questions

What parts do I need for the model water wheel generator?

DC motor 130 size (toy motor), LED 5 mm red, Resistor 220 Ω, Signal Diode 1N4148, Electrolytic Capacitor 100 µF, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the model water wheel generator take to build?

About 60 minutes for a beginner maker.