Idea
In short
How do you build a magnetic levitation demo?
An electromagnet and a hall sensor hold a small magnet floating in the air. You need Arduino Nano, A1302 linear hall sensor, IRF520 MOSFET driver module, Enamelled copper wire (magnet wire, 0.3 mm), Neodymium magnets (10 × 3 mm) and 12 V 2 A DC adapter.
- Level
- Advanced
- Time
- About 480 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Stabilise an unstable system.
Parts list
- Development Boards
- Sensors
- Motor Drivers
- Cables & Wires
- Mechanical & Hardware
- Power
How to build it
- Wind the coil
- Read the field
- Run PID fast
- Drive the coil with PWM
- Tune until it floats
Common questions
What parts do I need for the magnetic levitation demo?
Arduino Nano, A1302 linear hall sensor, IRF520 MOSFET driver module, Enamelled copper wire (magnet wire, 0.3 mm), Neodymium magnets (10 × 3 mm) and 12 V 2 A DC adapter.
How long does the magnetic levitation demo take to build?
About 480 minutes for a advanced maker.
