Idea
In short
How do you build an automatic gate opener?
A model sliding gate opens on a remote or RFID card, with obstacle stop and limit switches. You need Arduino Nano, TT gear motor 3 to 6 V, L298N Dual H-Bridge Module, Limit switch (micro switch with lever) × 2, RC522 RFID reader, IR obstacle avoidance sensor module, Active buzzer 5 V and 12 V 2 A DC adapter.
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Control a gate safely.
Parts list
- Development Boards
- Motors & Actuators
- Motor Drivers
- Switches
- Wireless
- Sensors
- Motors & Actuators
- Power
How to build it
- Move the gate along a rack
- Stop at both limits
- Open on an authorised card
- Reverse if an obstacle is sensed
- Close after a delay
Common questions
What parts do I need for the automatic gate opener?
Arduino Nano, TT gear motor 3 to 6 V, L298N Dual H-Bridge Module, Limit switch (micro switch with lever) × 2, RC522 RFID reader, IR obstacle avoidance sensor module, Active buzzer 5 V and 12 V 2 A DC adapter.
How long does the automatic gate opener take to build?
About 240 minutes for a intermediate maker.
