Idea
In short
How do you build a linear actuator position control?
Move a 12 V linear actuator to set positions using its feedback pot and a motor driver. You need Arduino Nano, Linear actuator 12 V (100 mm stroke), BTS7960 43 A motor driver, Potentiometer 10 kΩ and 12 V 2 A DC adapter.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Close a position loop on an actuator.
Parts list
- Development Boards
- Motors & Actuators
- Motor Drivers
- Passives
- Power
How to build it
- Read the actuator's position
- Drive it towards the setpoint
- Slow down near the target
- Stop within a dead band
- Add end limits
Common questions
What parts do I need for the linear actuator position control?
Arduino Nano, Linear actuator 12 V (100 mm stroke), BTS7960 43 A motor driver, Potentiometer 10 kΩ and 12 V 2 A DC adapter.
How long does the linear actuator position control take to build?
About 150 minutes for a intermediate maker.
