Idea
In short
How do you build a vibratory feeder controller?
Control the amplitude of a small vibration feeder with PWM so parts feed at a steady rate. You need Arduino Nano, MOSFET IRLZ44N, Rectifier Diode 1N4007, Potentiometer 10 kΩ, IR obstacle avoidance sensor module, Vibration motor (coin type) and 12 V 2 A DC adapter.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Drive an electromagnetic actuator.
Parts list
- Development Boards
- Semiconductors
- Semiconductors
- Passives
- Sensors
- Motors & ActuatorsUse a larger vibration motor for a real feeder
- Power
How to build it
- Drive the vibrator with PWM
- Count parts at the output
- Adjust amplitude to keep a steady rate
- Stop when the bin is empty
- Tune for different parts
Common questions
What parts do I need for the vibratory feeder controller?
Arduino Nano, MOSFET IRLZ44N, Rectifier Diode 1N4007, Potentiometer 10 kΩ, IR obstacle avoidance sensor module, Vibration motor (coin type) and 12 V 2 A DC adapter. Vibration motor (coin type): Use a larger vibration motor for a real feeder.
How long does the vibratory feeder controller take to build?
About 150 minutes for a intermediate maker.
