Components / Motors and drivers / BTS7960 43 A motor driver

BTS7960 43 A motor driver

High-current H-bridge for big DC motors.

FunctionH-bridge with two BTS7960 half bridges
Supply voltage6 to 27 V
InterfaceTwo PWM plus two enable pins
RatingUp to 43 A peak (realistic continuous much lower without cooling)
Motor DriversReviewedMPN IBT-2Used in 5 projects
In short

What is the BTS7960 43 A motor driver and what is it used for?

High-current H-bridge for big DC motors. Makers use it for heavy robots, e-carts.

How it works

Two BTS7960 half-bridge chips form a full H-bridge with built-in current sensing and protection.

Key specifications

Interface module specValue
FunctionH-bridge with two BTS7960 half bridges
Supply voltage6 to 27 V
InterfaceTwo PWM plus two enable pins
RatingUp to 43 A peak (realistic continuous much lower without cooling)
Logic level3.3 or 5 V

Pinout

RPWMPWM for forward
LPWMPWM for reverse
R_EN L_ENTie high to enable
R_IS L_ISCurrent sense outputs
VCC5 V logic
GNDGround
B+ B-Motor supply
M+ M-Motor

How to use it

Tie R_EN and L_EN high, PWM one of RPWM or LPWM and hold the other low. It drives big 12 V and 24 V motors, but continuous current without extra cooling is far below the 43 A peak. Fuse the battery line.

Applications

Alternatives

Buy at

Common questions

What is the BTS7960 43 A motor driver used for?

In maker projects: heavy robots, e-carts.

How does the BTS7960 43 A motor driver work?

Two BTS7960 half-bridge chips form a full H-bridge with built-in current sensing and protection.

What voltage does the BTS7960 43 A motor driver need?

6 to 27 V.

How do I connect the BTS7960 43 A motor driver to an Arduino or ESP32?

Two PWM plus two enable pins. Pins: RPWM (PWM for forward), LPWM (PWM for reverse), R_EN L_EN (Tie high to enable), R_IS L_IS (Current sense outputs), VCC (5 V logic), GND (Ground).

What can I use instead of the BTS7960 43 A motor driver?

Cytron MD10C 10 A motor driver and L298N Dual H-Bridge Module.