Projects / Ideas / Pocket colorimeter

Pocket colorimeter

IntermediateTest & MeasurementIdeaReviewed
In short

How do you build a pocket colorimeter?

A red or a green LED shines through a clear cup of water with a few drops of food colour into a light sensor, and the screen shows how much light gets through. Compare dilutions and see the relationship between colour strength and light. A classroom science tool, not a food or health tester. You need Arduino Nano, LED 5 mm red, LED 5 mm green, LDR Photoresistor, Resistor 10 kΩ, Resistor 220 Ω × 2, SSD1306 OLED Display, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 100 min
Parts
10
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Measure how much light a coloured sample absorbs.

How to build it

  1. Mount the LED and sensor on opposite sides of a dark box
  2. Read the empty reading
  3. Add a sample and read again
  4. Work out how much light is absorbed
  5. Plot absorbance against the number of colour drops

Related projects

Common questions

What parts do I need for the pocket colorimeter?

Arduino Nano, LED 5 mm red, LED 5 mm green, LDR Photoresistor, Resistor 10 kΩ, Resistor 220 Ω × 2, SSD1306 OLED Display, Tactile push button 6 mm, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the pocket colorimeter take to build?

About 100 minutes for a intermediate maker.