Idea
In short
How do you build an LED brightness versus current?
Step an LED through ten different currents and measure the light with a light sensor held a fixed distance away in a dark box. Plot brightness against current and see that it rises steadily and then flattens. It shows why more current is not always more light. You need Arduino Nano, LDR Photoresistor, Resistor 10 kΩ, LED 5 mm red, Resistor 220 Ω, Resistor 1 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 70 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Measure how bright an LED gets with more current.
Parts list
- Development Boards
- Sensors
- Passives
- Semiconductors
- Passives
- Passives
- Prototyping
- Prototyping
How to build it
- Fix the LED and the sensor in a dark tube
- Step the LED current with PWM and a resistor
- Read the light sensor at each step
- Print a table
- Plot brightness against current
Common questions
What parts do I need for the LED brightness versus current?
Arduino Nano, LDR Photoresistor, Resistor 10 kΩ, LED 5 mm red, Resistor 220 Ω, Resistor 1 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the LED brightness versus current take to build?
About 70 minutes for a intermediate maker.
