Idea
In short
How do you build a two MOSFETs at 5 V gate drive?
Switch the same small load with a logic-level MOSFET and a standard one from a 5 V pin and compare the voltage lost across each. You need Arduino Nano, IRLB8721 logic-level MOSFET, IRF540N N-channel MOSFET, Resistor 10 kΩ × 2, Resistor 330 Ω × 2, LED 5 mm white × 2, Digital multimeter and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
See why logic-level MOSFETs matter.
Parts list
- Development Boards
- Semiconductors
- Semiconductors
- PassivesResistor 10 kΩ × 2
- PassivesResistor 330 Ω × 2
- OptoelectronicsLED 5 mm white × 2
- Tools & Instruments
- Prototyping
How to build it
- Read Rds(on) at 4.5 V and 10 V
- Wire both with pull-downs
- Switch each on
- Measure the drain voltage
- Compare the drops
Common questions
What parts do I need for the two MOSFETs at 5 V gate drive?
Arduino Nano, IRLB8721 logic-level MOSFET, IRF540N N-channel MOSFET, Resistor 10 kΩ × 2, Resistor 330 Ω × 2, LED 5 mm white × 2, Digital multimeter and Breadboard 830 Tie Points.
How long does the two MOSFETs at 5 V gate drive take to build?
About 150 minutes for a intermediate maker.
