Idea
In short
How do you build a geyser timer with auto-off?
A button starts the bathroom geyser for 20, 40 or 60 minutes and a contactor-rated relay switches it off automatically to save power. You need Arduino Nano, TM1637 4-digit display, Tactile push button 6 mm × 2, Solid state relay SSR-40DA, Active buzzer 5 V and ABS project box (100 × 60 × 25 mm).
- Level
- Intermediate
- Time
- About 120 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Build a countdown timer that drives a high-current load through the right switching device.
Parts list
- Development Boards
- Displays
- Switches
- Switches
- Motors & Actuators
- Mechanical & Hardware
How to build it
- Use one button to pick 20, 40 or 60 minutes and one to cancel
- Count down on the TM1637
- Switch the geyser through an SSR on a heatsink rated well above its current
- Beep when it turns off
- A qualified electrician must wire the mains side and a proper MCB
Common questions
What parts do I need for the geyser timer with auto-off?
Arduino Nano, TM1637 4-digit display, Tactile push button 6 mm × 2, Solid state relay SSR-40DA, Active buzzer 5 V and ABS project box (100 × 60 × 25 mm).
How long does the geyser timer with auto-off take to build?
About 120 minutes for a intermediate maker.
