Idea
In short
How do you build a four-bit ripple counter?
Four flip-flops in a row, each clocking the next, count button presses in binary on four LEDs. It shows how each stage halves the rate of the one before, and why the counting ripples through. A good way to see binary and counting together. You need 74HC74 dual D flip-flop × 2, Tactile push button 6 mm, LED 5 mm red × 4, Resistor 220 Ω × 4, Resistor 10 kΩ, Ceramic Capacitor 100 nF, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 90 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Count in binary with four flip-flops.
Parts list
- Integrated Circuits
- Switches
- SemiconductorsLED 5 mm red × 4
- PassivesResistor 220 Ω × 4
- Passives
- Passives
- Prototyping
- Prototyping
How to build it
- Wire each flip-flop to toggle
- Clock the first with a debounced button
- Chain the outputs to the next clocks
- Show the four bits on LEDs
- Add a reset button
Common questions
What parts do I need for the four-bit ripple counter?
74HC74 dual D flip-flop × 2, Tactile push button 6 mm, LED 5 mm red × 4, Resistor 220 Ω × 4, Resistor 10 kΩ, Ceramic Capacitor 100 nF, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the four-bit ripple counter take to build?
About 90 minutes for a intermediate maker.
