Idea
In short
How do you build an ESP32 fall detector pendant demo?
An ESP32 reads a LIS3DH accelerometer and detects a drop followed by stillness, then sounds a buzzer. A learning demo only, not a medical alert or safety device. You need ESP32 DevKit V1, LIS3DH accelerometer, Active buzzer 5 V and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 170 min
- Parts
- 4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Learn how a fall can be spotted from motion.
Parts list
- Development Boards
- Sensors
- Motors & Actuators
- Prototyping
How to build it
- Wire the sensor on I2C
- Read acceleration
- Spot a near-zero drop then an impact
- Check for stillness afterwards
- Sound the buzzer and allow a reset
Common questions
What parts do I need for the ESP32 fall detector pendant demo?
ESP32 DevKit V1, LIS3DH accelerometer, Active buzzer 5 V and Breadboard 830 Tie Points.
How long does the ESP32 fall detector pendant demo take to build?
About 170 minutes for a intermediate maker.
