Projects / Ideas / Diode forward voltage shootout

Diode forward voltage shootout

BeginnerTest & MeasurementIdeaReviewed
In short

How do you build a diode forward voltage shootout?

Put a signal diode, a rectifier diode, a Schottky diode and a few LEDs in turn in a simple resistor circuit and read the voltage across each with a multimeter at two different currents. You see why the drop differs and which diode wastes the least. You need Signal Diode 1N4148, Rectifier Diode 1N4007, Schottky Diode 1N5819, LED 5 mm red, LED 5 mm blue, Resistor 1 kΩ, Resistor 220 Ω, 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 45 min
Parts
11
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Rank four diodes by how much voltage they drop.

How to build it

  1. Wire the 1 kΩ resistor in series with a diode
  2. Measure the drop across each diode
  3. Change to 220 Ω and measure again
  4. Test the red and blue LEDs the same way
  5. Make a table and pick a diode for a reverse-polarity guard

Related projects

Common questions

What parts do I need for the diode forward voltage shootout?

Signal Diode 1N4148, Rectifier Diode 1N4007, Schottky Diode 1N5819, LED 5 mm red, LED 5 mm blue, Resistor 1 kΩ, Resistor 220 Ω, 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the diode forward voltage shootout take to build?

About 45 minutes for a beginner maker.