Idea
In short
How do you build a diode direction tester?
Touch the two leads of a small diode to a pair of probes and a red or a green LED tells you which way round it is, with neither lit for a broken or open diode. No microcontroller is needed, only a few parts and a small battery. Use it to find the stripe end of diodes. You need 9 V battery, 9 V battery snap with DC jack, LED 5 mm red, LED 5 mm green, Resistor 1 kΩ × 2, Signal Diode 1N4148, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Beginner
- Time
- About 60 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Find the stripe end of a diode with two LEDs.
Parts list
- Batteries
- Power
- Semiconductors
- Semiconductors
- PassivesResistor 1 kΩ × 2
- Semiconductors
- Prototyping
- Prototyping
How to build it
- Connect the red LED so it lights for one direction
- Connect the green LED the other way round
- Add a resistor in each branch
- Test a 1N4148 both ways
- Test an LED and a resistor to see what happens
Common questions
What parts do I need for the diode direction tester?
9 V battery, 9 V battery snap with DC jack, LED 5 mm red, LED 5 mm green, Resistor 1 kΩ × 2, Signal Diode 1N4148, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the diode direction tester take to build?
About 60 minutes for a beginner maker.
