Projects / Ideas / Cut-track repair practice

Cut-track repair practice

BeginnerTest & MeasurementIdeaReviewed
In short

How do you build a cut-track repair practice?

Cut a copper track on a scrap board with a craft knife, check with a meter that it is broken, then bridge it with a short wire and solder, and check again. A real skill for fixing old boards. The iron is hot, so use a stand and ventilation, and keep the knife pointing away from you. You need Copper clad board (single side) 10 × 15 cm, Soldering iron 60 W (adjustable temperature), Solder wire 60/40 (0.8 mm, 50 g), Magnifier lamp (LED) and Digital multimeter.

Level
Beginner
Time
About 60 min
Parts
5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Repair a broken copper track on a board.

How to build it

  1. Draw a track with a marker and etch or scribe it
  2. Cut a gap and check it is open
  3. Bridge it with a thin wire
  4. Solder both ends
  5. Check continuity and the resistance of the repair

Related projects

Common questions

What parts do I need for the cut-track repair practice?

Copper clad board (single side) 10 × 15 cm, Soldering iron 60 W (adjustable temperature), Solder wire 60/40 (0.8 mm, 50 g), Magnifier lamp (LED) and Digital multimeter.

How long does the cut-track repair practice take to build?

About 60 minutes for a beginner maker.